|
Mounting the PUTT-TRAINER on your putter (magnetic metal properties):
 The
PUTT-TRAINER is pre-assembled for use with standard putters. When using
a "Futura" putter, the PUTT-TRAINER (picture 1) is attached
to the front hole without an adapter. If you have a putter with magnetic
properties, simply place the PUTT-TRAINER on or above the head of the
club. If the PUTT-TRAINER fits better when turned around through 180°,
simply remove the adapter and reassemble it in the new position. The
PUTT-TRAINER is not suitable for putters with a centrally fitted shaft.
Important: The adapter should be centrally
mounted on the putter head!
Example of magnetic metal porperties Putter:
Also suitable for putters with non magnetic properties!
The adapter supplied is affixed to your putter using double stick tape
strips. The adapter should be centrally mounted on the putter head. You
can attach it at either point A or point B. Clean the surfaces on both
the putter and the adapter where double stick tape will be applied, using
either spirit or window cleaning fluid. Take a suitable double stick tape
and stick it onto the appropriate area of the adapter. Apply firm pressure
for 5 secs. The next step is to stick the adapter onto the putter head.
Caution: Take care to stick on the adapter straight and in the exact center
of the cub. Remember to apply firm pressure for 5 secs. The adapter only
weights 4 grams and can therefore remain permanently attached to the putter.
Alternatively, it can be removed and remounted at any time again.
Important: Take care to stick the adapter on straight
and in the exact center of the club.
Attention: double sticks tape strips are in the
box beneath the case liner.
To assemble the Adapter for non magnetic putter:
|
|
|
| Adapter with possible examples A or B |
Douple stick tape for A |
Douple stick tape for B |
Other examples of A:
Other examples for B:
|
